– Name : F1r3Fly’s G3 Mod
– Creator : F1r3Fly
– Length : 21 cm
– Weight: 18 g
– Insert : Non
– Link : F1r3Fly’s G3 Mod (Japanese)
– Making : Quite hard
– Materials :
– 1 Pilot G3 Metal ( Everything except grip and backcap)
– 1 Pilot G2 ( Back )
– 1 Faber Castell Grip Matic ( Tip )
– 1 HGG ( Tip and Grip )
– 1 Dr. Grip ( Grip )
– 1 Karstadt Kulli / Sailor ( Grip )
– Estimated cost : Around 13€.
– Tutorial :
1- Disassemble the G3 and cut the screw thread. File down the undergrip.
2- Cut the G2 body at 5.6cm.
3- Cut 7.4cm of the G3 inktube. It is advised to empty it beforehand. Put some sticky paper on its back.
4- Empty the grip matic tip and put it on the front of the inktube.
5- Put the grips on the G2 according to the picture.
Put the prepared inktube in the G2 body. You can add an insert around the inktube.
6- Place what you did on the previous step on the front of the G3 body. You can also place an insert in the G3 body.
7- Remove the rubber stopper from the G3 cap and put the G3 tip inside. Cut 0.5cm of the HGG grip, wrap an insert around the bigger part and put it in the cap.
8- Put the HGG tip in the cap, followed by the remaining part of the HGG grip so it doesn’t rattle.
9- Put grips on the cap. Wrap tape around the back of the G3 body and put the cap there.