Featured picture : credit goes to Vore-Tex.
– Name : Neptunus
– Creator : Vore-Tex
– Length : 21cm
– Weight : 19-20g
– Insert : No
– Weblink : Neptunus (Vore-Tex website)
– Difficulty : A bit hard
– Stuff :
– 2 Pentel RSVP Grips)
– 2 Pentel VFeel BXCB ( 2 back barrels, 1 grip)
– 2 Pilot Juice up (Tips)
– 2 Stalogy (Backplugs) whatever the version
– 1 old Zebra Sarasa (Grip)
– 2 Pilot Airblanc (Grip) or Silicone tube 10x8mm
– 1 Anyball/Supergrip/G2 (Grip)
– 1 Pentel HGG (Grip)
– 1 Uniball GP (Grip) : or use the thinnest grip you have.
.
– Tutorial :
1- Take your VFeel apart and cut the barrel to 3,6cm :
2- Clean the inside of the part :
3- Thanks to a pipe cutter, cut your stalogy backplug to 8,6mm and add some layers of clear tape on the thread part (not shown):
4- Cut the HGG grip to 5,5mm-6mm
5- Cut the GP grip to 1,2cm
6- Assemble steps 3-, 4-, 5- with Juice up tip. If you don’t have GP grip, use the thinnest grip you can get.
As reference, this tip stack weight 3,9g.
Note for hardcore modders : from my measurements, GP grip is 0.75mm thin while G3 is 0.83mm and Needle line is 0.71mm.
7- Put onto the VFeel barrel : half sarasa grip, half vfeel grip with the tip stack inside + 2cm of airblanc grip :
8- 1 piece of 3 stripes of Anyball or Supergrip/G2
9- Cut 1.5cm of the RSVP grip :
10- Put this grip into the VFeel barrel and push the PC2 barrel :
11- Repeat the steps for the other side and you’re done ????
– Comment :
As RPD said, “it feels like an ikusafude (in the sense that it’s short-ish and very overgripped) but of course it’s thinner since it’s a pc2 mod. I don’t have a nectalios but I’ve spun one in the past and this is kinda like a lighter nectalios”.
– Video :
