Featured picture : credit goes to Magiai.
– Name : GioGear
– Creator : Magiai
– Length : 27.1cm
– Weight : ~19g
– Insert : No
– Weblink : GioGear (Magiai website)
– Difficulty : Medium (Extremely hard if you use a small plastic tube)
– Stuff :
– 1 Thick Supertip diameter barrel (used as a connector)
– 1 Small plastic tube (the base non stretched one can fit inside flexgrip body)
[Editor’s note : you should be able to use silicone pipe as grip]
.
– Tutorial :
Global Diagram
1- Cut 7 mm from the front of the Giotto barrel (keep the cut part)
2- Scrape the inside of both front parts (wood carving tool is useful here)
3- Cut 3cm of the Giotto cap (flat part)
4- Cut the small part of the top of the giotto cap (separate the inside bit from the outside barrel)
5- Cut 8mm from the inner part of giotto cap
6- Connect the flat inner part of the giotto cap on the tip of the front
7- Add the remaining inner giotto cap part inside the front
8- Cut a ring from the plastic tube and put it on the structure (so it will not rattle inside the cap).
9- Using a lighter, stretch the plastic tube to put it on the giotto cap. Make it so that it connects to the front (so no tape is used)
10- Cut more sections of plastic tube and add it on the giotto body (acting as decorative grip)
11- Cut ~1cm of tube and put it on the center of your st size connector (the length of it is ~4cm)
12- Connect (picture as guide) on the body
13- Repeat on the other side and connect to the center part.
– Comment :
Ingenius way to make a mod out of 2 giotto. As Magiai said, “The GioGear is a TitanGear-inspired mod made as an ultimate cheap alternative. Basically, There is virtually no way to do a cheaper “TitanGear” type mod (For me at least).”
