1-Clear the G3 front (remove grip)

2-File down the nubs on the G3 front, as well as the raised area next to where the tip is attached.

3- Cut approx. 1cm of the Hyper Jell grip and slide it onto the G3’s grip area.

4- Cut approx. 1cm of the unknown grip (I recommend using Jimnie or Hyper Jell) and slide it next to the Hyper Jell grip.

5-Attach a Hi-Tec C tip to the G3 plastic tip, then attach a Signo tip on top of the Hi-Tec C tip. Screw the G3 tip onto the G3’s threads. You should have three pen tips on the front of the G3.

6- Slide the Signo grip over the three tips.

7- Cut a design into your Signo Knock grip, then put it on top of all the other grips at the front of the G3.

8-Put a few sections of Anyball/Profile in front of the cut grip. The front of the pen is complete!!! Good job.

9-Cut the Hyper Jell cap’s clip.

10- Put the other Signo tip into the Hyper Jell cap like you would while making an Ayatori Mod.

11-Put the other Hi Tec C tip and the HGG tip into the rest of the Hyper Jell grip. Put the grip into the Hyper Jell cap (HGG tip first) (Hi-tec> HGG> Signo)