Credit goes to Mesi for the tutorial video.

__

– Name : Mesi G3 Mod

– Creator : Mesi

– Length : ~ 19.5cm

– Weight : 14g

– Insert : Yes

– Link : Mesi G3 Mod (YouTube)

– Making : Difficult

– Pens list :
– 1 Pilot G3 (Plastic ver.) (Barrel, Tip, Backplug)
– 2 Zebra Hyper Jell (1 Cap, 2 Grips)
– 1 Uni-Ball Signo DX (Tip + Grip)
– 2 Pentel Hybrid Gel Roller (HGR) (2 Tips)
– 1 Dong-a Anyball (Grip)
– 1 Pentel RSVP (Inktube)

– Tutorial :

1- Clear the G3 front. Remove the grip and sand down the small squares, the front and the screw thread

2- Apply some adhesive to the inside of the Signo tip, then screw it onto the G3 front

3- Drill a hole into the G3 backplug until the RSVP inktube tip fits snugly in the hole

4- Plug the RSVP inktube into the G3 backplug, and trim the inktube until it fits snugly within the G3 barrel

5- Add an insert into the G3 barrel and plug the G3 backplug with the inktube back into the G3 barrel (the RSVP inktube should be inverted, with the tip of the inktube poking out of the backplug)

6- Screw on the HGR tip onto the plastic G3 tip. Then, apply some adhesive onto the inside of the plastic G3 tip and place the tip stack onto the Signo tip. Your tip stack should look like this : (G3 front> Signo> plastic G3 tip> HGR tip)

7- Wrap some electrical tape onto the back of the G3 barrel.

8- Cut a Hyper Jell grip to 0.6 cm and the Anyball grip to 3 blocks. Then, stretch your Signo grip until its slightly longer.

9- Put the Hyper Jell grip section onto the G3 front first, followed by the stretched Signo grip and the 3 block section of Anyball grip.

10- Cut the clip of your Hyper Jell cap. Then, put the second Hyper Jell grip into the cap. Afterwards, plug the second HGR tip into the Hyper Jell cap.

11- Attach the cap to the G3 barrel.

– Comment :
This mod is great and well made.

– Videos :