RSVP v1, RSVP v2, RSVP Mx - The Pen Modding Wiki

Credit goes to Kam for the featured picture.

the rsvp mx isn’t the first mod of kam, his first mod was the rsvp v1

– RSVP v1 Tutorial :

1- Take the rsvp and take off the backcap, ink and cap.

2- Break the rsvp clip and sand it with sand paper.

3- Inktube Turn upside down in the body of RSVP, make a hole in the backcap RSVP for the inktube.

4- Put an insert.

It is far from kuzu G3 Mod and other Impact Mx, etc.. This is comparable to the Nintendo 64, now we have the PlayStation 5, it runs better.

Just RSVP v2, already a little better.

– RSVP v2 Tutorial :

1- Take the rsvp and take off the backcap, ink and cap.

2- Break the rsvp clip and sand it with sand paper.

3- Inktube Turn upside down in the body of RSVP, make a hole in the backcap RSVP for the mine to go.

4- Remove HGG tip and grip.

5- Screw HGG tip abive RSVP tip (you can put patafix or teflon between the two tips).

6- Put HGG grip on the front of RSVP body.

7- Print an insert of 8.8 x 3.8 cm and place it in the body of RSVP.

8- Replace backcap on the RSVP and heading it over.

But “What is changing, so the RSVP MX?” you tell me. Well you missed a detail, there is no grip in the cap of the RSVP RSVP v2, unlike Mx.

The tutorial is not to add the one hand it is already on the site, and another I guess and I hope you know by heart is not very complicated.