Credit goes to TEK for the featured picture.

__

– Name : Reeder Mod

– Creator : Tek

– Length : 19 cm

– Weight: Oui

– Link : Reeder Mod

– Modding : Difficult

– Pens list :

– Tutorial :

1-Take clip off of the g3 cap and cut off the excess. Wrap electric tape as shown

2- Cut small part of RSVP grip (about 0.5mm) and wrap it around the telescopic tip. Then stick it in the cap. should be fairly tight in there.

3- Cut 4 sections off the g3 grip. Then wrap an insert around it and stick it into the cap…part 1 should look similar to this. make sure there is a good amount of space left so it can fit on the g3 body later, if not, cut the grip a little more.

4- Cut off the small nubs on the g3 then shave it down a bit. then cutt off the top part leaving only 8mm. take out the small back plug and put in an insert, then remember to put the back plug back in! Btw…dont shave down too much of the g3 part but you might need to go back to the shaving step later.

5- Cut like shown. It should be 3.5 cm long

6- Add some tape at the bottom of the tip of Bic RT

7- Put insert in the g2 barrel, then stick the tip in like so. if the tip is too loose, add more tape around the base. remember to leave some free room at the bottom where there is no insert

8- Add anyball grip. Part 3 should look like this..

.

9- Cut the g3 cap. it should be exactly 4 cm. then add tape as shown

10- Wrap a thing layer of tape around the base of the g3 tip

11- Stick the tip inside of the cap and push it all the way up. it should stay in tightly. If not, add just a little bit more tape. Add anyball.

12- Wrap about 10.5 cm of electric tape 4 cm down the ink tube starting at the very tip of the ink tube. Then add a small about down at the bottom.

13- Now the 5 Parts are done. (see link).

14- Assembled parts.

– Comment :

Such a beauty.  It’s still a very ingenious model that offers us Tek, King of modding.

– Videos :