Fenboss

Featured picture : credit goes to Varoza.

– Name : Fenboss

– Creator : Varoza

– Length : 23~24cm

– Weight :  21g

Insert : No

– Weblink : Fenwiki’s article

– Difficulty : Easy~Medium

– Stuff :

– 2 Emboss(One Barrel, two small caps)
– 2 Uni-Ball Alpha Gel(tips)
– 2 Pilot Dr.Grip(Grips)
– 2 Anyball/ Pilot G2 (Grips)
– 2 Pentel ColorTwin/ACT(Big caps)
– 2 Thin grips(Pentel HGG and Pentel RSVP grips are advised)
.

– Tutorial :

1- Empty your Emboss barrel (remove the nibs and the ink). Replace the Emboss backplug when done

2- Cut the small Emboss caps from the lip to 8-10mm each and place both on both side of the emboss pen

3- Hollow both CT/ACT caps (this can be done by hitting the center segment with a mallet or a hammer)

4- Cut your Pilot Dr.Grip grip to 2.5~3cm long (depending how you like it) then place both segments on the CT/ACT caps while leaving a bit of space for the tips

5- Cut 2x 3 section of your Anyball/G2 grips (From the side with the big ring if Anyball is used)

6- Remove the ring on both Alpha Gel tips and put 3 section of your Anyball/G2 grips onto it

7- Push both tips in the Dr.Grip grips until the Anyball/G2 grips fit against the CT/ACT caps

8- Cut 2 small section of your thin grips and put it on the remaining section of the Emboss front / backplug

9- Push both caps on the thin grips until both fit snug (Use a lubricating substance to help, this step is the hardest.) (If too much force is applied, the CT/ACT caps could break)

Complete!

(Aditionnal Diagram by Xeran (Note that the the thin grip is missing in the picture.))

– Comment :
The Fenboss was structered in a way to avoid any rattling. It is a great mod for Linkage tech based spinning, it was notably used by Nine in the cv: “Fen 2nd”.

Categories
Latest Posts
Ads