Featured picture : credit goes to .

– Name : Menowa* G3 (現行G3)

– Creator : Menowa*

– Length : ? cm

– Weight : ? g

– Insert : Yes

– Weblink : Menowa*’s Tumblr

– Difficulty : Medium

– Stuff :

– Tutorial :

1- Remove the G3 grip, and sand down the small squares as well as the front

2- Cut the G2 barrel to 4.6 cm from the screw thread end (Make sure the cut is perfectly flat, cut a few millimeters longer if you plan to sand down the cut)

3- Cut the Color Twin barrel to 3 cm, also make sure the cut is perfectly flat

4- Cut off the Jimnie cap’s clip

5- Stack the HGG tip on top of the Airblanc tip (use adhesive to hold the stack together), and put the tip stack into the Jimnie cap

6- Wrap an insert around the Color Twin barrel and put it into the Jimnie cap, then cut 7 blocks of Anyball grip and put it onto the cap

7- Attach the Airfit LT tip onto the G2 barrel (on the cut end without the screw thread)

8- Wrap an insert around the front of the G3 barrel, and put the G2 barrel onto the front of the G3 (screw thread part goes on first)

9- Put 1 block of Anyball on the G2 barrel, followed by an Airfit metal ring, and a whole Anyball grip (1.8 cm of the G2 barrel from the screw thread is exposed) (there will be a gap between the Anyball grip and the Airfit LT tip). Fill the gap between the Anyball grip and the Airfit LT tip with a suitable grip.

10- Wrap some vinyl tape around the back of the G3 barrel, and attach the cap onto the barrel. Adjust COG if necessary

Complete!

– Comment :
nil