Featured picture : credit goes to Light.
– Name : Light G3
– Creator : Light
– Length : ?
– Weight : ?
– Insert : Yes
– Weblink : Light’s Youtube
– Difficulty : Medium
– Stuff :
-1 Pilot G3 (Barrel)
-2 Uniball Signo (Tips)
-1 Pentel KT/CT (Small cap)
-1 Zebra Jimnie (Cap, Grip)
-1 Pen’zGear (Cap)
-1 Bic Round Stic (Barrel)
-1 Pilot Supergrip (Grip)
–Some suitable grips
– Tutorial :
1- Put a Signo tip into the small KT cap
2- Cut the clip of the Jimnie cap and put the KT cap with Signo tip into the cap
3- Cut 7-8mm of Jimnie grip and put it into the cap
4- Clear the G3 front, and cut the front to 1 cm
5- Sand down the G3 front until the Pen’zGear cap fits on snugly
6- Put some suitable grip into the G3 front before putting the Pen’zGear cap onto the G3 front
7- Cut 2.5 cm of Bic barrel and put it onto the Pen’zGear cap (use tape on the cap if it doesnt fit snugly)
8- Put the whole Supergrip grip on the Bic barrel (flat side out) and put the last Signo tip into the grip
9- Add some tape to the back of the G3, add an insert and attach the cap to the barrel
Complete!
– Comment :
Quite the unique G3, using a Pen’zGear cap for the front. One of the other mods I’ve seen which uses a Pen’zGear cap apart from Menowa*’s STA Gear