Featured picture : credit goes to Beta.

– Name :  Wanna VP

– Creator : wanna

– Length :  19 cm (depends on how far you push in the cap)

– Weight :  ~14g

– Insert : Yes

– Weblink : wanna’s Blog

– Difficulty : Easy

– Stuff :

– Tutorial :

1- Disassemble your RSVP. Remove the backplug and screw the Jetstream tip onto the rear screw threads, replacing the backplug (You may need to file or sand down a bit of the screw threads for the tip to screw on fully) and add an insert into the barrel

2- Remove and cut the clip of the G3 cap and remove the rubber stopper in the cap

3- Cut 2 blocks of Anyball grip and place the 2 blocks into a Signo tip

4- Place the Signo tip into the G3 cap

5- Place the Signo Broad grip into the G3 cap

6- Attach the G3 cap to the RSVP barrel

7- Screw on the HGG tip onto the RSVP barrel

8- Place a Signo tip onto the HGG tip, then use some tape to secure the tip

9- Place the Lakubo grip onto the front of the RSVP barrel, fill in the leftover space with scrap grip (wanna used cut Lakubo grip to fill in the gap)

Complete

– Comment :
There are different variants of Jetstream out there, the one used here is the  SXN-155 model