Featured picture : credit goes to Timeless.
– Name : Timeless G3 mod
– Creator : Timeless
– Length : 19.5cm
– Weight : 13.5g
– Insert : Yes
– Weblink : Timeless discord msg
– Difficulty : Medium
– Stuff :
– Tutorial :
1- Clear your G3 (remove grip, inktube, sand down the front)
2- Cut the front of the G3 to 1.7 cm
3- Hollow out the big Emboss cap using a chopstick (put chopstick into cap and push hard)
4- Remove the rubber nub on the Frixion cap and put it inside the HGG tip
5- Cut your Hyper Jell grip to 0.7cm
6- Cut 2 blocks off your Anyball grip
7- Take your 2 blocks of Anyball , and put over the Hyper Jell grip
8- Put the Hyper Jell grip with Anyball inside your Emboss cap, leaving one block exposed
9- Take Step 4 and put it inside the Hyper Jell grip (Frixion rubber nub facing out)
10- Cut your leftover Hyper Jell grip to 0.5 cm
11- Cut Supertip cap starting from the front to 1.6 cm
12- Cut the G3 cap to 0.7 cm from the front
13- Put the Hyper Jell grip onto the G3 front, followed by Supertip cap, then place the cut G3 cap onto the Supertip cap with an insert under it followed by the Emboss cap (HJ grip> Supertip cap with G3 and Emboss cap)
14- Cut your Comssa barrel to 4.3 cm from the front (tip side)
15- Remove the plastic piece in the Frixion cap, and hollow the G3 rubber stopper with a RSVP inktube (use the back of the inktube and push hard to hollow)
16- Cut your Anyball grip to 5 blocks and put it on the Frixion cap
17- Put the HGG tip into the Frixion cap, followed by the Comssa barrel (HGG tip with G3 rubber stopper inside< Comssa barrel)
18- Put some tape on the back of the G3, put an insert into the G3 and attach the cap
Complete
– Comment :
There are praises for this G3 mod, seems like a nice mod
*Note: that this is the variant of Emboss that is used for the cap
**Note 2: the mod has 2 slightly different variation, the first one uses sanded PC2 barrel instead of ST cap, 4 blocks of anyball grip at step 16, and HGG tip< Comssa barrel< O ring at step 17. This version is 12.32g for 20cm
