IM* Hybrid

Featured picture : credit goes to Vôre-Tèx

– Name : Ivan-Menowa* Hybrid (IM* Hybrid)

– Creator : Vôre-Tèx

– Length : 22cm

– Weight : 22g

Insert : No

– Weblink : >Vôre-Tèx blog<

– Difficulty :  Medium

– Stuff :
– 1 Ivan mod base (That’s to say, 1 whole ST with 1 half on each side)
– 2 Anyball (Grips)
– 2 CT/KT (Big caps)
– 2 Dr.Grip HDG-50R (Tips)
– 2 Sailor gel sub (Grips)
2 metal rings (0.8gr each, ID6mm and OD11mm) ; Can be change by Penzgar rings

Stuff price : Around 20 USD

– Tutorial :

1- Prepare your Ivan mod base for 17cm long

2- Cut CT cap at the red line. Keep 19mm of the thinner part :

3- With a circular file, sand inside of the CT cap so the tip can fit inside :

3- Cut your anyball grip as shown. Keep 9 stripes from the front

4- Use your plier to stretch the sailor grip (it’s better to use a sub, the one that feels more plastic than silicon, because it is slightly heavier) and add it above CT caps :

5- Optional : Add the metal ring as shown

6- Add the anyball grip above sailor gel grip sub. The front of the grip should be on the side of the clip of the cap :

7- Attach each cap on each edge of the Ivan mod base =) use tape is needed.

14- Adjust the center of gravity with tape.

– Comment :
Most of the best spinners in fpsb are using this penmod (such as gollumsk8 or thebeygeek). Gollumsk8 used it during the World tournament 2017 (he got the 2nd place).
An huge momentum and a wide spinning area. If you know how to control your pen, you should appreciate the IM hybrid =)

All comments.