Featured picture : credit goes to Vôre-Tèx for the picture.
– Name : 400¥ G3
– Creator : Vôre-Tèx
– Length : 21 cm
– Weight : 14 g
– Insert : Yes
– Weblink : Vôre-Tèx Twitter
– Difficulty : Easy
– Stuff :
– 1 Pentel e.ball (Grip, Clicker)
– 1 Uni-ball Signo DX (Tip, Grip)
– 1 Pilot Supergrip.G ( Cap, front barrel)
.
– Tutorial :
1- Remove the clip of the cap of the Supergrip.G
Cut off the screw thread of the front of Supergrip.G and remove the small bumps.
2- Cut the DX grip as shown.
3- Keep the clicker of the e.ball and cut it as shown. Keep the grip.
4- Prepare the G3 front barrel. (remove grip, sand down the small squares and front)
5- Attach the e.ball clicker, G3 tip and Signo tip together with tape.
6- Add the DX grip and e.ball grip over G3 front barrel, with the tip stack.
7- Add the Supergrip.G front barrel into its own cap.
8- Add the DX grip with the G3 backplug on the Supergrip.G cap. Add some around of tape on the G3 backplug so it won’t fall down when you drop the pen.
4- Add an insert in the G3 barrel and push the cap onto the back of the G3.
– Comment :
I made this mod just for fun at first, like a challenge, and tried to make the cheapest G3 mod I could while I was in Japan during the summer of 2018. I don’t know why but I succeeded in making something not bad. Maybe the mod is a little bit too long for some people, but it is easy to spin!
– Video
