Featured picture : credit goes to Migi
– Name : Migi G3 Mod
– Creator : Migi
– Length : 20.5cm
– Weight : 15.5g
– Insert : Yes
– Link : Migi G3 mod (GPC)
– Difficulty : Medium
– Pens :
– 1 Zebra Hyperjell ( Cap + Grip )
.
– Tutorial :
1- Keep all the stuff you need.
2- Remove the G3 grip without cutting it. Prepare the front of the barrel as usual. Remove the screw thread.
3- Remove the grip of the HGG. Cut 3.2cm from the front of your HGG barrel (count the tip in)
4- Connect the step 2 and 3 with adhesive tape.
5- Put the HGG and hyperjell grip as shown. Cut the ring of the HGG and 0.8cm of the hyperjell.
6- Screw HGG tip and with blue tack, screw Signo tip over.
7- Cut your G3 grip and keep the block part. Add this piece next to the HGG grip.
8- Over the grips, add 1 stripe of sailor gel, your cutgrip and 4 stripes of sailor gel again.
The front is done.
9- Cut the clip of the cap.
10- Put HGG tip into the G3 tip.
11- Hyperjell grip is 1.6cm and Signo broad grip is 0.6cm.
12- Add step 10 and 11 into the cap.
13- Add some electrical tape at the back of the G3 for the cap.
– Comment :
If you like the concept of the kuzu G3 mod, but want a lighter pen (since kuzu G3 is around 20g), I think this one should be perfect for you. 🙂