Cafca G3 (new ver.)

Featured picture : credit goes to.

– Name : Cafca G3

– Creator : cafca

– Length :  ?cm

– Weight :  ?g

Insert : Yes

– Weblink : Cafca’s Twitter

– Difficulty : Easy

– Stuff :

-1 Pilot G3 (Barrel, Grip)
-1 Pilot Hi-Tec C Maica (Tip, cap)
-1 Platinum Gel Roller (Grip)
-1 Pilot Dr. Grip HDG-50R (Metal ring)
-3 Pentel Hybrid Fine/ Hybrid Gel Grip (Tips)
-1 Hyper Jell/ Jimknock/ Jimnie (Grip)
-1 Pilot Hitecpoint V5/7 Grip (Cap)

– Tutorial :

1- Disassemble your G3 and sand down the front

2- File down/ cut off the bump on the side of the Hi-Tec C Maica cap

3- Cut 2 blocks of G3 grip and put it onto the Dr. Grip ring

4- Put the Gel Roller grip onto the front of the Maica cap

5- Put the Hi-Tec C tip onto the cap (onto the gem looking part) and put the Dr. Grip ring onto the cap (held by the grip)

6- Wrap an insert around the front of the G3 and put the Maica cap onto the front of the G3 (wrap some tape as well if it doesn’t hold)

7- Remove the clip of the Hitecpoint cap (the metal part)

8- Cut the Hyper Jell grip to 2.75 cm from the front (the rounded part)

9- Stack the HGG tips and put them into the front of the Hyper Jell grip section inverted

10- Cut a 4mm section of Hyper Jell grip and put it into the longer Hyper Jell grip section through the cut end

11- Put the long section of Hyper Jell grip into the cap (tip side goes in first)

12- Wrap some tape on the back of the G3 and attach the cap


– Comment :

Diagram from cafca