under"Mebius" - The Pen Modding Wiki

Featured picture : credit goes to .

– Name : under”Mebius”

– Creator : VAIN

– Length : 19.8 cm

– Weight : g

– Insert : Yes

– Difficulty : Easy

– Stuff :
-2 Pilot G3 (Barrel, 1 Metal tip, 1 Plastic tip, 1 Rubber Stopper, Grip) (VAIN used a tinted barrel)
-1 Uni-Ball Signo DX (Grip)
-1 Pilot Supergrip (Grip)
-1 Pilot Frixion Colors (Cap)
-1 Zebra Hyper Jell/ Jimknock (Grip)
-1 Zebra D1-k (Grip)
-1 Pilot Hi /G -Tec C (Tip)
-1 Zebra Rubber 80 (Tip)
-1 Zebra Jell.Be (Tip)
-1 Pentel Hybrid Fine (Backplug)
-1 Dong-a Anyball (Grip)

– Tutorial :

1- Clear the front of the G3 barrel (remove grip, sand down front and small squares)

2- Cut the Signo DX grip to 1.2 cm from the front and put it onto the front of the G3

3- Cut off the small tip on the G3 rubber stopper so that there’s a hole and put it into the front of the G3 (in the screw thread area)

4- Screw on the Plastic G3 tip onto the barrel

5- Put the whole Supergrip grip onto the front of the G3 barrel (striped part facing out)

6- Put the Hi-Tec C tip into the Supergrip grip, followed by the Metal G3 tip (tip stack will be Plastic G3> Hi-Tec C> Metal G3)

7- Clear the Frixion colors cap (remove rubber nub, plastic piece and remove the small clip on the side)

8- Screw the Jell.Be tip onto the Rubber 80 tip

9- Insert the tip stack (?) into the Frixion Colors cap Rubber 80 tipfirst (the Jell.Be tip should be facing the inside of the cap) (Jell.Be <> Rubber 80 ->)

10- Cut your Hyper Jell/ Jimknock grip to 3.1-3.2 cm from the rounded side and put it into the cap

11- Cut 3 blocks of G3 grip, 2 blocks of Anyball grip and 3 blocks of D1-k grip

12- Put the G3 grip section onto the cap first, followed by the Anyball grip section and finally the D1-k grip section

13- Cut the Hybrid fine Backplug to 8mm from the rounded end and plug it into the top of the Frixion Colors cap

14- Wrap a small strip of tape around the back of the G3 barrel (VAIN only wraps the tape around halfway around the barrel) and add an insert

Complete!

– Comment :
A G3 on the heavier end from VAIN
This mod was named after a song
Jell.Be, plastic G3 and D1-k are rather hard to find, though Jell.Be can be found under J-Roller RX