Featured picture : credit goes to.

– Name :  G-COLORS

– Creator : Coffeelucky

– Length :  cm

– Weight :  g

– Insert : Yes

– Weblink : Coffeelucky’s Instagram

– Difficulty : Easy

– Stuff :

– Tutorial :

1- Remove the grip from the G3 and sand down the small squares and the front ledge (sand down the front ledge until it is level with the G3 tip, else it will be unbalanced from too much sanding)

2- Remove the plastic piece in the Frixion Colors cap, keep the rubber on the cap

3- Cut 1 cm of Signo grip and put it on the Frixion Colors cap

4- Put a HGG tip into the cap followed by the HGG grip. Put the second HGG tip into the HGG grip

5- Cut your G3 grip vertically, roll it up and put it into the HGG grip in the cap

6- Cut 1.6 cm of Signo grip and put it onto the G3 front

7- TIp stack Plastic G3 tip> Supergrip tip with G3 rubber> Signo tip

8- Put the Supergrip grip over the tip stack, with the flat part of the grip facing out

9- Add an insert into the G3 barrel, then add some tape on the back of the G3 before attaching the cap to the barrel

Complete

– Comment :
-Nil-