BT MX

Featured picture : credit goes to Mina.

– Name : BT MX mod

– Creator : Mina

– Length : ~20 cm

– Weight : ? g

Insert : No

– Weblink :  Mina’s Blog

– Difficulty : Easy

– Stuff :

– 1 Nitoms Stalogy (Barrel) (MP or BP are fine)
– 1 Bic Round Stic (Barrel)
– 1 Pentel HGG/HGR(Tip, Grip)
– 1 Pentel RSVP (Cap, Grip)

.

– Tutorial :

1- Disassemble your Stalogy and cut 2cm from the back (depending on how long you want the mod to be, cut accordingly)

2- Cut the Bic Barrel as shown from the front to 3.5cm (not including the tip)

3- Place your HGG/HGR tip onto the front of the Bic Round stic. If you are using HGG, the tip should screw onto the front of the Bic without any problems. If you are using HGR tip you will need to use tape to hold the tip to the front of the Bic. (If you don’t want to use tape you could experiment with a G3 rubber to hold the tip down)

4- Put your HGG or HGR grip onto the Bic barrel

5- Cut the clip of your RSVP cap, and put the RSVP grip into the cap

6- Put Step 4 into the front of the Stalogy barrel (the Bic tip will hold it in) and the cap on the cut side of the Stalogy barrel (You may need a small portion of tape.)

Complete

– Comment :
From Mina: Honestly, if you don’t like spinning MX, don’t make this mod. You’ll hate yourself for cutting up a BT and making a mod that spins like MX. On the bright side, if you think MX is cool and you wanna spice it up a bit, this is a great way to do that, especially if you like rubber barrels. Another good thing about this mod is that you can make an Extended Stalogy with the BT internals, so in my opinion, deciding to make this mod results in a win-win situation. Lastly, this same exact concept can be applied to Kacogreen barrels, so if you want to make a KGMX, go for it 🙂