– Name : Mx²
– Creator : Tek
– Length : 19.5 cm
– Weight : 14 g
– Insert : Yes
– Link : Mx²
– Making : Difficult
– Stuff :
– 2 RSVP ( 1 Barrel + 1 Cap + 2 Grips + 1 Backcap )
– 2 HGG ( 2 Tips + 2 Grips )
– Tutorial :
1-Remove the grip of each pen and cut the small ring at the end of each grip
2- Remove the small plastic lip on the front of RSVP barrel.
3- Take 7 cm of adhesive tape and wrap it around the front of the RSVP barrel (where there was RSVP grip).
4- Put some teflon on the tip of RSVP body.
5- Put the ring of the RSVP and the ring of the HGG and put these on the front of RSVP body. The tape should allow them to not move on the rsvp front barrel.
6- Put 2 HGG tips with teflon on the front of RSVP barrel.
7- Take an other part of adhesive tape (7cm) and wrap it on the front of RSVP barrel above HGG tips.
8- Place the whole HGG grip on the front of RSVP barrel.
Front is done 😀
9- Take RSVP backcap and drill it, as for RSVP MX.
10- Cut the clip of the RSVP cap.
11- Take the 2 last HGG and RSVP grips and cut the ring of each of them.
12-Glue the rings together.
13- Put HGG grip inside of the RSVP cap.
14- Put rings glued in cap.
15- Take the rest of the grips of RSVP and cut to half.
16- Tuck one of those pieces of grip in the course and stuck it between the rings and the HGG grip.
17- Screw BackCap on the thread of RSVP with InkTube upside.
18- Place the cap.
– Comment : A version may be more appreciated than the Mx normal thanks to its larger length and weight. It also looks very nice.