Animal G3 Mod

Credit goes to An[!]Mal for the featured picture.


Name : Animal G3 Mod

Creator : An[!]Mal

Length : 20,6 cm

Weight : 18 g

– Insert: Yes

– Link : Animal G3 Mod (FPSB)

Difficulty : A bit hard

Stuff :

– 1 Pilot G3 (barrel, inktube)
– 1 Hyperjell (cap, grip)
– 1 Signo Broad (cap, grip, tip)
– 1 Faber Castell Grip Matic (barrel, tip)
– 1  Sailor (grip)
 Pieces of grips

Tutorial :

1- Remove the clip of Hyperjell cap and file it. Put Signo Broad tip in Signo Broad grip, and put it on Hyperjell cap.

2- Take G3 barrel and cut both first one stripes  from the back (see link).

3- Cut the body where you cut the grip on the last step, File it.

4- Take a piece of G3 inktube (see link) and put chatterton above this part. Put this inktube on G3 body and put Grip Matic tip also above this parts (see link).

5- Take your Faber Castell Grip Matic’s body. Saw to keep just the piece where there was a grip. Put an piece of grip of 0,9cm on the body of G3. Put one suite the whole grip of Hyperjell on the body of G3 and on Faber Castell Grip Matic’s body.

6- Take Signo Broad cap. Cut where there is “the ring”.

7- Take the piece of Signo Broad cap and put it on Hyperjell grip.

8- Put Grip Matic tip and put it in the front of G3 inktube. Do like the picture:

9- Mod done (:

Comment :
Here, a very good use of the barrel of Pilot G3 and the barrel Of the Grip Matic, but  may be difficult to make for a few ppl (cut the body of G3 and the cap of Signo Broad for example).

All comments.
  1. avatar

    Thanks Hirako =)

  2. Comments are closed.