Credit goes to Vôre-Tèx for the featured picture.
__
– Name : Hs mx
– Creator : Mr.MSC
– Length : 18-20 cm
– Weight : Mx < Hs Mx < Impact mx
– Insert :.Yes
– Link : HS Mx / LHS Mx (UPSB)
– Making : Difficult
– Pens list :
– 1 Sunburst (All parts)
– 1 Metal G3 (cap, tip)
– 1 HGG (grip, tip)
– 2 Anyball (grips)
– 1 G3 tip or Signo tip
– Tutorial :
1-Take the RSVP body and file down the front. Also, put on the front some tape
2-Take your RSVP grip and cut off the first section of the grip. Slide that onto the front of the pen
3-Take your HGG grip and cut off the first section of the grip as well. Slide that onto the front of the pen
4-In addition, cut off another section of the HGG grip. Save this piece, it will be used later.
5-Take what you have left of the RSVP grip and cut as shown in the picture. Slide that onto the front of the pen
6-Take what you have left of the HGG grip and slide that onto the front of the pen.
7-Now take your Anyball/Profile grip and cut the grip into sections of 3,6, and 2
8-Use the section of two and slide that on top of the connection between the cut RSVP grip and the HGG grip.
9-Now, this step is to test how long the G3 cap should be cut. Put the HGG tip onto the front of the pen and the G3 tip after that. The lip of the G3 tip should line up with the HGG grip. If it doesn’t, it means that you did not cut off enough of the HGG grip. Now slide the Anyball/Profile grip on top of the G3 tip. It should look something like this
10- Now measure the space between the Anyball/Profile grips and cut the G3 cap to that length. File/sand down the G3 cap as needed and slide that on top of the HGG grip.
a. (Adding tape on top of the HGG grip can be done at this point.)
b. (In addition, you can actually put an insert there. [Props to pholord]
11- Now use teflon tape/hot glue/super glue to attach the HGG tip/G3 tip to the front of the pen. Slide the Anyball/Profile grip back over and you have completed the front of the pen.
12- Screw the RSVP back plug onto the pen and put an insert in.
13- Now take the RSVP/Sunburst cap and remove/completely file down the clip. In addition, put the remains of the RSVP grip and HGG grip in the cap
14 – Take the 6 Anyball/Profile cells and slide that on top of the RSVP cap. If it is too hard, cut the profile into smaller sections.
15- Repeat with the other Anyball/Profile grip. This time use fewer sections than 6 and put that on top of the Anyball/Profile already on the cap
– Comment :
There are many versions how to make the Cap of RSVP.
Le bon moddeur en question, c’est Feuille ? Ü
Megas ^^
Ah ok, même combat XD